Swivel Caps need to be cleaned by hand using a non abrasive, neutral pH, mild detergent that does not contain a sheeting agent.
- Remove o-ring from cap.
- Inspect gasket for signs of wear.
- Spray and wipe the o-ring with 70% IPA (isopropyl alcohol).
- Rinse with Dionized Water.
- Replace o-ring in cap.
- Autoclave to sanitize.
SafeWASTE & Swivel Cap Autoclaving Tips:
- Recommended cycle for autoclaving is 121ºC and 15psi for 20 minutes.
- Remove cap from carboy or container prior to autoclaving.
If the containers are not vented properly during the autoclaving and cooling process, a partial vacuum could form causing the bottle to collapse. The cap should remain disengaged until the carboy reaches room temperature.
Swivel Caps may appear cloudy after autoclaving due to adsorption of water. Cloudiness will dissipate as the plastic dries, but can be accelerated using a dyring oven.
|Swivel Cap Size:||83mm|
|Ports:||6 each ¼-28 threads|
Limited Quantities Available. Discontinued when sold.
Swivel Cap Kit for HPLC Vapor Containment System with Ease of Use. Includes one 83mm “Swivel Cap” (HD polypropylene screw cap with turning wings for tightening, independent center tubing holder and solvent resistant gasket), one SafeVENT™ filter with one 90º elbow fitting, 6 each male nut fittings & ferrules for 1/8th tubing (blue, not shown above), 6 each male nuts & ferrules for 1/16th tubing (green) & 6 solid male nut fittings.
Swivel Cap with 83mm threads is for use with most HD SafeWASTE™ HPLC Solvent management system carboys (sold separately). Cap can be applied or removed from carboy without turning the tubing holder making it very convenient to change full carboys without re-plumbing cap or twisting waste tubing during removal. With ease of use, compliance by lab personnel is increased.
The independent center tubing holder has 6, ¼-28 screw thread ports that accommodate the supplied low pressure male nuts to securely hold waste tubing from the HPLC instrument producing a closed system that will prevent exposure to harmful organic vapors. Supplied solid-plug male fittings are used on the holder when some of the ports are not in use. A closed system also prevents spill incidents from HPLC solvent waste.
SafeVENT™ is a carbon filter that traps (VOC) organic vapors and safely vents the closed system preventing pressure build up.
*A use indicator for the SafeVENT™ that indicates when replacement is needed is available and sold separately. Other tube holders that fit this cap for larger size tubing are sold separately.
Swivel Cap Kit, 83mm with a SafeVENT™ Filter 1/EA - Limited Quantities Available
- Product Code: CM10-330-0411-1
Tags: Swivel Cap Kit, SafeWASTE™, HPLC, CSC